Lilitab Desk Stand

Set Up Guide

Shipment Content:

• 1 x Countertop Basic Mount
• 1 x Compact Metal Base
• 4 x Compact Base Screws
• 1 x Phillips Screwdriver
• 1x Key

Quick Setup:

1. To open the faceplate, squeeze & hold the two buttons at the back of the faceplate while sliding the bezel upwards (opposite to the RFID reader).

2. Connect the NFC reader to the USB charging cable, switch the toggle to Bluetooth, and place it in the Lilitab case.

3. Connect the NFC reader to the USB charging cable, switch the toggle to Bluetooth, and place it in the Lilitab case.

3. Connect the iPad to the lightning charging port inside the Lilitab case and then place the iPad in the Lilitab case.

4. Secure the iPad into the case by sliding the faceplate towards the NFC reader and clicking it into place. Verify it is properly locked.

5. Please follow the NFC reader connection steps from your registration software provider. Do not add a Bluetooth device right away via iPad settings.

6. Please follow the NFC reader connection steps from your registration software provider. Do not add a Bluetooth device right away via iPad settings.

7. Place the completed faceplate onto the Mag Dock of the Lilitab stand. It should sit tight and secure.

8. With the provided key, lock the case onto the desk stand. Keep the key secure for removal.

9. Adjust the viewing position by tilting the iPad up and down.

10. Once the iPad is set up and attached to the Lilitab floor stand, your device will be ready for use.