Space Mast Desk Stand

Set Up Guide

Shipment Content:

1 x Vesa Base Stand
1 x iPad Enclosure
1 x Toolkit with Keys
1 x Cable Lock (optional)

1. The base and the iPad enclosure are packaged separately. First, unbox the Vesa Base stand and place it on a flat surface, followed by the included toolkit. For now, set the iPad enclosure aside as it will be installed later.
2. Run the iPad charging cable through the stem of the desk stand.
3. If you are unable to run the charging cable through the stem, use the provided green T20 wrench to remove the stem cover.
   • Unfasten the screws found on the front along the stem. See image 1.
   • Remove the stem cover and set it aside.
   • Run the charging cable through the stem, ensuring it passes through the backside of the stand for a clean and organized setup. See image 2. The angled end of the USB-C cable goes to the iPad.
   • Replace the plastic stem cover and fasten the two screws.

4. Tilt the top of the base so it is parallel to the flat surface. See image 3

5. Using the provided key, unlock and remove the bezel from the housing of the iPad enclosure.

6. Route the charging cable through the center of the enclosure and lay the cable to the side. See image 3.

7. Place the enclosure in the desired orientation before securing it onto the desk stand. The iPad enclosure does not rotate once installed.

8. Align the enclosure with the holes on the desk stand and fasten them using the provided screws and screwdriver.

9. Attach the charging cable to the iPad, leaving a small loop of cable beneath the tablet.

10. Align the bezel with the housing and place it over the iPad. See image 4.

11. Secure the bezel in place by pushing in the lock on the side of the housing until it clicks in place. See image 4.

12. If the iPad housing tilts freely or does not stay in position, use the provided green T20 wrench to tighten the screws on the front of the stem until it holds the desired angle. See image 5.

Optional Accessory:
13. Wrap the cable lock around a solid object and pass the lock through the loop.

14. Insert the lock into the small slot on the back of the iPad stand and lock it with the provided key