Pedestal

Set Up Guide

1. Unbox the pedestal and remove all the tape to release the 4 pieces.
2. Grab the largest piece and fold it into a column. Get both ends together and hold them in place.
   
3. Remove the adhesive protection strip.
   
4. Tightly seal both ends together with the adhesive strip. Push firmly and slide your finger top to bottom to avoid bubbles and wrinkles.
   
5. Place the pedestal upright with the sloped, finished end to the top. The angled top allows the lid to sit flush.
   
6. Assemble the brace panels by aligning the slits and interlocking them to form a (+) shape. If the brace panels do not fit evenly and only one panel touches the ground, please disconnect the panels and carefully lengthen the slit with a box cutter
   
7. Insert the brace panels into the pedestal base with each end on a side to fortify the pedestal.
   
8. Attach the top by aligning it with the base and gently pressing down until it is securely in place. It must sit flush.

Ready.

Have a successful Event!

Troubleshooting

What if brace panels do not fit evenly and only one panel touches the ground?

Please disconnect the panels and carefully lengthen the slit with a box cutter.