Zebra ZC10L

Set Up Guide

Step 1

Remove printer from the case. Grab the printer from the bottom on both sides using the space provided in the case. The printer is heavy, make sure to have a firm hold of the printer when pulling it out.

Step 2

Insert cleaning roller. See image below and/or scan this QR code for a video guide.

a. Place the printer on a flat surface and open the top door.
b. Push the cleaning roller into place as shown until you hear an audible click. Pay close attention to the rollers end, the thicker end goes to the left. Please see the diagram below.

Step 3

Install Print Ribbon. See image below and/or scan the QR code for a video guide.

a. Slide the supply spool into the guide rails and toward the rear of the printer. The White end of the Roll must go in first on the left side, matching the White Canal.
b. Slide the take-up spool into the guide rails and toward the front of the printer.

Step 4

Insert the Plastic Cards: First, open the front drawer by pressing the card drawer release button.

Step 5

Pull on the blue latch and insert the Plastic cards as shown below. Fan them out to remove any static charge from the cards.

Step 6

Place the Card Pickup Tray on the outside door and close the front cover.

Step 7

Insert the Power Cable into the rear of the printer.

Step 8

Connect one end of the USB cable to the rear of the printer and the other end to your laptop.

Step 9

Flip the power switch to On.

Step 10

Disposing of card waste.

a. Open the card drawer by pressing the card drawer release button.
b. Remove the waste bin and empty the contents into a trash receptacle.
c. Re-insert the waste bin.
d. Close the card drawer.

Download this Guide

ZC10L Setup Guide

Manufacturer Documentation

ZC10L User Guide

ZC10L-User-Guide

ZC10L-Setup-Guide

Hardware and Software

• Zebra ZC10L Hardware Driver & Software